Off-road driving can damage brake sensor wires.
Provided you happen to be driving off-road in your Chevy Motor lorry and the anti-lock brake warning light suddenly comes on, chances are skilled that the wiring on one of the wheels became snagged and torn. When this happens, the rotate rush locution that is sent to the Chevy's personal computer was interrupted and the warning clear was turned on. Observe Everyone of the wheels and glimpse for the wiring harness that routes from the Motor lorry object to Everyone of the wheels. The anti-lock brake wiring harness is encased in a nigrous, woven mesh to protect the wires inside. Establish the damaged wires.
Repair the wire whether it is not besides badly damaged, or alter the sensor, and the blaze Testament birr gone.
Instructions
1. Jack up the Motor lorry and city jack stands under the frame.2. Incision the torn divide elsewhere of the harness. Strip a 1/4 inch of insulation off of each end of the segmented wire, using a wire-stripping tool. Cut One inch of shrink-wrap tubing and slid it over the wire. Twist the two wire ends together and use a soldering iron to heat them, then add a small amount of solder to hold them together. Slide the shrink-wrap tubing into place and use a propane torch to shrink the tubing to tightly grip the repaired wiring.
3. Pull the woven mesh together to cover the repaired section. Use small black zip-ties to cinch the mesh into place. Snip off the excess tie. This will hold the mesh in place and the black color will blend in.
