Govern and lasting the calipers a unusual times to compose confident it continuously goes to nonentity. Re-tighten the screw.2. Occupation the Mitutoyo calipers in your deserved artisan and open the jaws using the thumb wheel, located to the right of the dial.
By production definite to cipher your calipers before any measurement, you can assure that your efforts creature in the most accurate measurements credible.
Instructions
1. Blank the calipers to receive an accurate measurement. To determine so, hurried the calipers and occupancy them up to a illumination source to research for gaps. Disinfected the blades and hurried them again provided there are gaps. Unscrew the retaining screw located on the top of the dial. Turn the dial bezel until the indicating marker is on the nil spot.
Convenience Mitutoyo CalipersThere are a infrequent ways in which to advantage Mitutoyo calipers To gauge in a machine-shop or engineering setting. By conscious the equitable road to construe the calipers, you can degree outer diameters, inner diameters and holes with validity and celerity.Hold the part to be measured in your left hand.
3. Place the part in between the jaws of the calipers and slowly close the jaws so that the blades touch each side to be measured. Use the numbers to the left of the pointer on the slide of the calipers for the first part of the measurement, which indicates inches and hundredths of an inch. For instance, if the pointer on the slide is to the right of the big One and just past the smaller three, then the first part of the measurement is 1.3 inches. Append the number indicated on the dial, so if it is at 50, which is an actual reading of .050 inch, then the total measurement would be 1.350 inches.
4. Use the Mitutoyo calipers To gauge an inner diameter. Close the calipers and place the smaller blades that point upwards inside of a tube or other space that needs to be measured from the inside. Slowly open the calipers until the small blades touch each side of the inner space. Read the measurement in the same manner as indicated in Step 3.
5. Use the calipers To gauge hole depth. Open the calipers to past the presumed depth of the hole. Lower the thin stick-like metal rod sticking out of the back end of the calipers into the hole until it touches the bottom. Press down on the calipers so that the back end touches the top of the hole. Read the calipers as in Step 3.
