Instructions
1. Turn the metre on. When the metre is on, the exposition Press-stud says "With gallon preset," which method it is calibrated at mill preset to the viscosity of water.Calibrate a FlowmeterA flow metre is a Slogan used To gauge the linear, nonlinear, Bulk or volumetric flow ratio of a liquid or Gauze. Nevertheless how conclude you be schooled whether your flow metre is accurate? By calibration: a step by which the manner of an instrument is checked against a principles with a high rise measure of rectness. The flow metre is calibrated by weighing the sum of any liquid or Gauze that passes completed it during a persuaded measuring date.Hold down the "Calibrate" button and switch it to "Leaders" preset. Hold down the button till it says "Cal B." This means that this is no longer a factory preset but something you can change.
2. Hold the "Display" button for four or five seconds or until it says "DD Cal," which means dispense display. Let go when it says "Run 01." Put the flow meter in the sample fluid. When you do this, the little turbine shows up at the bottom left, which confirms that the meter now has fluid going through it.
3. The display button now says how much water you put in it. You can change this display to the amount of liquid you ran through the flow meter. If you measured Five gallons of water in the meter, hit the "Calibrate" button five times.
4. Hold down both the "Display" and "Calibrate" buttons. It now says "Run 02," which means you can do another sample if you like. If you don't want to do another sample, just hold both buttons until it says "Cal end."
