Ford Fusion Door Panel Emigration
The Ford Engine Corporation introduced the Fusion in the Two thousand six model-year in the USA. Ford considered the Fusion as a replacement for the Convoy and marketed it to the duplicate demographic. Honorable as with the Convoy, any daily grind needed to one of the Fusion's interior door components must headmost embark on with door panel Emigration. With the honest tools and some basic Car repair skill, you can corner the door panel off your Fusion in under Thirty minutes.
Instructions
Pry the round trim cover out of the bottom of the door pull pocket. Remove the screw underneath the cover with the Phillips head screwdriver. Pry the door pull out of the door with the trim tool then disconnect the wiring harness from the window switch by hand.4.
2. Pry outside the round trim cover behind the door handle using a pocket screwdriver. Remove the screw behind this trim cover with a Phillips head screwdriver.
3.1. Pry outside the door haft bezel using the trim baggage. You can pick up a trim effects at decent approximately any Car parts retail Issue.
Remove the upper rear and upper front round trim covers with the Phillips head screwdriver then remove the exposed screws with the Phillips head screwdriver. Remove the screw from the bottom center of the door panel next.
5. Lift the door panel up and off the door and set it aside.
