Alter Honda Civic Brake Pads
The Honda Civic is one of the most flourishing admitted Japanese cars. The Civic is a also dependable, well-engineered compact motorcar that has been nailed down various redesigns over the elderliness. As department of routine preservation, the Civic’s brake pads should be inspected regularly and replaced whether de rigueur. This is a business that can be done by a able shop or by an amateur mechanic with the licence tools and advance.
Instructions
1. Arena the van on a Apartment lodgings, alike surface that is flourishing lit. Application a lug wrench to loosen the wheel’s lug bolts. Lift the vehicle with a floor jack and column it on jack stands. You can cause the front brake pads and then the rear brake pads whether you prefer. Stop the Emigration of the lug bolts and the wheels.
2. Establish the brake caliper bolts, which are located on the top and backside of the caliper facing the spin fit. Loosen and remove the lower caliper bolt with a socket and ratchet. You Testament admit to Celebrate the inboard follower with an open-ended wrench to loosen the bolts. Focus the caliper on the upper caliper bolt up and elsewhere from the rotor.
3. Remove the brake pads and the brake pad shims from the caliper carrier with your hands. These Testament simply slide gone. Remove the brake pad retaining clips from the caliper carrier.
4. Repeat the above steps for the remaining corners of the vehicle. The rear pads are changed in the same manner.8.
5. Apply a thin coat of the assembly paste to the side of the shims that go against the brake pads and the back of the pads. Do not get any paste on the rotor or surface of the pads that touch the rotor. Install the new pads and shims in the caliper carrier.
6. Remove the lid of the brake master cylinder and remove about one-half inch of brake fluid. Place the caliper piston tool on the caliper piston and the caliper body. Compress the piston into the caliper.
7. Slide the caliper back over the rotor. Install the caliper bolts and tighten them with the socket and ratchet. Spray brake cleaner on the caliper, bracket and rotor and dust everything down with a Disinfected rag. Handle a thin layer of meeting glue on to the brake pad retaining clips where they mount on the caliper carrier. Install the clips in the caliper carrier.
Reinstall the wheels. Lower the vehicle to the ground and tighten the lug nuts. Fill the master cylinder with fresh brake fluid and tighten the lid. Pump the brakes until the pedal feels firm.
