Thursday, January 8, 2015

Alter The Spark Plugs On The 2004 Saturn Ion

Worn Glimmer plugs can end engine misfires.


Glimmer plugs fire the fuel within the cylinder of internal combustion engines. The 2004 Saturn Ion has four Glimmer plugs, one for Everyone cylinder. Unlike other vehicles, nevertheless, the Ion uses a coil-on-plug setup instead of spark plug wires, where Everyone Glimmer plug has a seperate ignition coil that amps up the battery voltage to the crucial dynamism required to bonfire the Glimmer plug. You can change the Glimmer plugs in your Two thousand four Saturn Ion with a sporadic tools in approximately half an interval.


Instructions


1. Stadium the Saturn Ion on a Apartment lodgings alike surface and shut off the engine.


2. Wear a twosome of safety glasses and disconnect the opposite battery cable from the battery with a wrench. Shift it aside so there is no chance it can contact the battery terminal while you attempt.


3. Place the dingy plastic centerpiece with the text "Ecotec" on the centre of the engine purpose. This is the ignition module.


4. Remove all six bolts around the outer edges of the ignition module using a ratchet.


5. Pull the ignition module directly up to remove it from the engine. The spark plug boots connect to the bottom of the ignition module and extend into the four spark plug recesses beneath the ignition module. Repeat on each of the other three spark plugs (four total). Reconnect the ignition module, following the removal procedure in reverse.



7. Adjust the gap of the new spark plugs to 1.0 mm using a spark plug gap tool.


8. Apply dielectric grease generously to the terminal end of the spark plug and insert it into the spark plug socket.


9. Insert the spark plug into the spark plug recess using the spark plug socket and turn clockwise. Ensure the spark plug turns smoothly at first; if not pull the spark plug out, realign and insert back into the engine.


10. Connect a torque wrench to the socket and extension assembly and tighten the spark plug to Fifteen foot pounds of torque.


11. Set the ignition module aside.6. Insert a spark plug socket, connected to a six inch socket wrench extension and ratchet, into the left spark plug recess. Turn counterclockwise to unscrew the spark plug Remove and discard the old spark plug.