The brakes on your Dodge Ram perform a imperative avail. As hydraulic fluid is forced over steel lines, the fluid actuates a piston in a caliper mechanism that sits over a CD, called a brake rotor. This rotor is connected to the impel wheels and moves with them. When the caliper piston is forced outward, the pads inside the caliper clamp down on the rotor causing friction between the two components. The pad data begins to disintegrate in the mode of turning motility into heat complete this clamping manner, which creates a abundance of friction. Over extent, the pad facts Testament not gain Sufficiently friction information left to create an direct gig of slowing the vehicle down. The piston Testament collapse back into the caliper housing. Beget positive that the piston boot on the caliper does not be remodelled disoriented, twist or rip.10. Insert the new brake pads into the caliper assembly and reassemble the brake assembly.
Loosen all of the trundle lug nuts by turning them Fourty five degrees counterclockwise, however achieve not unseat the trundle from the shove hub.
2. Jack up the front of the Ram. Levy the floor jack under the vehicle and jack up on the front jack location, located rear the radiator.
3. Situate jack stands under the front pinch welds and lower the vehicle onto the stands.
4. Repeat Steps One and Two for the rear of the Dodge using the rear jack location this date. Build decided that you levy a jack stand under Everyone of the rear pinch welds and lower the vehicle onto the jack stands.
5. Remove the lug nuts and pull the wheels off of all of the trundle hubs.
6. Remove the upper and lower caliper mounting bolts.
7. Pull the Ram's caliper up off the rotor and secure it to the coil springs above the rotor.
8. Remove the brake pads from the caliper using a immature rubber mallet.
9. Press the caliper piston back into the caliper meeting. Distance the face of one of the brake pads over the piston and beef the pad against the piston with a C-clamp. This happens when the pad info is approximately an eighth of an inch thick. At that end, you'll obligation to moderate the brakes on your Dodge Ram.
Instructions
1.Tighten the caliper mounting bolts to the torque specifications set in your Dodge Ram's service manual. Different years may have different torque specifications according to the generation of the vehicle.
11. Spray the brake rotors, pads and calipers down with brake parts cleaner to remove any remaining brake dust, oil (from your hands) and grease.
12. Put the wheel back on the wheel hub assembly and tighten the lug nuts.
13. Lower the Dodge Ram to the ground and torque the lug nuts to One hundred foot-pounds with the torque wrench.
