All Jeeps enjoy a radiator coolant calm sensor.
The coolant sensor in a Jeep tells you when the coolant in the radiator becomes further low to safely impel the vehicle. Whether this sensor fails to inform you via the sprint panel luminous and an audible beeping sound, you may not apprehend that the radiator has sprung a leak. Draining Two gallons should trigger the sensor, and the "Coolant" light should illuminate on the dash panel. If it does not, the sensor is defective. If it does, the sensor works.4.
Habitat a void pan directly under the petcock on your radiator. The petcock is on the Chauffeur's side and at the backside of the radiator.
2. Twist the petcock counterclockwise with a team of pliers and empty Two gallons of fluid into the filter pan. Rapid the petcock by turning it clockwise with the pliers.
3. Turn the Jeep on for a two minutes. The light should come on when the coolant levels in the radiator begin to fall. This could leave you stranded by the side of the pathway, or worse, it could leave you with a scarce thousand dollars in engine repair bills. Whether you agitation your Jeep's coolant sensor isn't working, there is one facile hook to troubleshoot the complication.
Instructions
1.Open the radiator cap on the top of the radiator and place a funnel into the hole. Drain the coolant back into the radiator.
