A properly working door arm makes for an big-league belongings of your Chevy S-10 provided you cook not craving to receive into your Motor lorry cherish a "Dukes of Hazzard" television star. The metal used to manufacturer the brackets on the door handgrip, established as "pop steel," is a relatively soft metal normally used on low-wear items. Over period, but, the brackets can alter to decrepit and eventually hole.
Instructions
1. Bare the door, and remove the screws that secure the inner door panel to the stage metal on the inner door with a screwdriver.
Lift up on the handle from the outside door, and remove the two bolts located under the handle with wrenches. The bolts secure the handle to the sheet metal on the outside of the door.6. Pull the handle out of the door.
3. Establish the back of the door use by looking through the upper holes in the sheet metal. On the left side of the door handle, you'll see a long bar connected to a piece of metal on the side of the handle. The bar moves when you lift up on the handle and opens the door latch.
4. Remove the metal bar from the left side of the handle by pulling the bar to the left. (The bar is not attached with bolts.)
5.2. Pull on the upper left corner of the door to loosen the door panel from the chapter metal. Immature plastic tabs connect the door panel with the episode metal approximately every Ten inches. As you pull on the panel, pull the tabs outside of the folio metal.
