Always isolate the battery for your safety.
The starter in a 1993 Ford Explorer is the most meaningful bite of the Motor lorry's electrical course. The starter receives the electrical expression to engage the flywheel and dawning the engine. When the starter goes malicious, the Motor lorry Testament not inception. The starter is located under the Motor lorry between the engine and the transmission. Replacing the starter should catch half an age as it's easily accessible and held to the frame by two bolts.
Instructions
Removing the Old Starter
1. Up thrust the hood to place the battery. Disconnect the battery before attempting any duty on the electrical transaction.
2. Crawl under the vehicle on the passenger side. Allot the starter between the engine and the transmission.
3. Unscrew the clear-cut wires on the starter with a socket wrench. Unscrew the aficionado and pull the wires off the stud. Screw the stone back onto the stud for safekeeping. Accommodation a group of masking tape on the concrete leads to remind you which wires are which.
8. Mount the new starter to the frame with the socket wrench. Make sure that both bolts are tight.9.
Unbolt the starter from the frame. There Testament be a bolt at the top and another at the backside. Undo these bolts with a socket wrench.
6. Pull the starter away from the truck. The starter may be stubborn to remove. Tap it with a hammer to free it from the frame if necessary.
7. Place the old starter in the box the new starter came in. You will need to save the starter to return it for a core credit.
Installing the New Starter
4. Unscrew the denial terminal on the starter and pull the wires off the stud. Screw the immature fan back onto the stud.5.
Unscrew the small nut on the positive terminal. It will be designated by a plus symbol. Peel the masking tape off the positive wires then tighten the wires onto the stud.
10. Unscrew the nut from the negative stud. Place the negative wire onto the stud. Tighten the nut over the lead with a socket wrench.
11. Connect the battery by tightening the positive cable onto the positive terminal with the socket wrench. Connect the negative (black) wire to the negative terminal.
12. Start the truck to ensure the starter is functioning correctly. The truck should start as soon as you turn the key.
