The Mercury Villager was manufactured as a Seam bag between Mercury and Nissan. The Villager was a larger minivan than others on the bazaar. The Villager's suspension features event springs on the rear and coil springs in a MacPherson strut on the front. Replacing the coil springs in a Mercury Villager is not as complicated as with homogenous minivans.
Loosen the strut seed and community a spring compressor onto the coil spring in computation to compress the spring. Apply caution during this course as the coil spring carries a extravagant deal of strength which must be released carefully to avoid bodily injury.4. Alter the strut shaft kernel and grip the upper mounting bracket off before removing the next: front strut bearing and the bearing seat, coil spring seat and dust boot.
Block the wheels with jack stands and lift the Villager before removing the strut and spring meeting.
2. Assign the strut meeting into a vice and remove the strut kernel involve.
3.
Instructions
Replacing the Front Springs
1.5. Catch the coil spring and compressor off the strut. Slowly Proceeds the tension on the spring and remove the insulator and catch the suspension bumper off the strut before replacing the spring.
6. Reverse the steps to reinstall the dewy coil spring and strut components. Beget definite the spring is seated properly on the spring seat and avail a late strut shaft devotee. Be certain to tighten the seed to manufacturer's specifications.
7. Lower the Villager and remove the jacks and jack stands. Perform a safety trial.
Replacing the Rear Springs
8. Elevate the Villager and operate jack stands to secure it. Place the jack stands directly on the frame in front of the mounts for the event spring.
9. Uplift the rear axle until the spring's tension is relieved before removing the adjacent: four page spring U-bolt nuts and washers, two U-bolts, upper spring pad, and upper spring seat, phase spring rear shackle nuts, shackle edge plate and the shackle.
10. Revenue off the rear leaf spring front follower and hurl it absent before removing the front bolt on the period spring.
11. Adjust the heighth of the Villager to remove the leaf spring.
12. Take note of the inner and outer markings on the mounting plate (see Tips) before installing the the leaf spring front bolt. Place the rear end of the spring below the bushing on the chassis and slip the shackle through the bushing and the rear spring.
13. Raise the rear axle until the alignment bolt slides into the correct hole in the axle pad before reinstalling the following: shackle end plate, shackle nuts, new leaf spring front nut, two U-bolts, upper spring pad, and upper spring seat, U-bolt washers and nuts. Tighten all nuts and bolts according to specifications for the Villager's specific model year.
14. Take the jack off the rear axle and lower the Villager. Remove jack stands. Perform a safety check before driving.
