The Toyota Corolla was manufactured with an optional air conditioning method, which uses a compressor circulate freon on ice the evaporator and condenser. This compressor can wear elsewhere and have need replacement, which should capture the morals backyard mechanic approximately an interval to all-inclusive.
Instructions
1. Remove all of the freon coolant inside of the air conditioning development by captivating the vehicle to a garage or oil spending money centre and having them evacuate it elsewhere. The freon should not be vented into the atmosphere, and these troop centres prompt paid To gather it with defined Accoutrement. Most Testament evacuate the development for for love.
2. Disconnect the battery by turning the worthy terminal bolt counterclockwise.
3. Remove the freon lines from the compressor by turning the border nuts counterclockwise. There may be a slender vastness of covert impact yet in the method, however it should not hiss continuously.
4. Remove the operate belt from the compressor pulley rotate by firmly urgent on the torsion pulley arm until there is Sufficiently slack to slide the region from underneath the idle pulley. Release the tension pulley arm, and the belt should have the slack to take it off the compressor pulley wheel.
5. Reconnect the battery by turning the positive terminal bolt clockwise.11. Refill the system with freon using a kit--use kit manufacturer's manual--or by taking the vehicle to a professional facility.
7. Replace the compressor by positioning it into the mount arms, then sliding the mount bolts into place. Turn the nuts clockwise until they are firmly seated. Reconnect the wiring harness by plugging the adapter into the terminal.
8. Reconnect the freon lines to the compressor by turning the line nuts in a clockwise direction. Check the gaskets while reinstalling them.
9. Replace the drive belt by wrapping it over the compressor's pulley wheel (grooves down), then pushing on the tension pulley arm to slide the belt underneath the idle pulley. Release the tension pulley and the belt will tighten.
10. Disconnect the compressor from the wiring harness by pulling the adapter plug from the terminal on the compressor.6. Remove the compressor's mount bolts by turning the nuts counterclockwise and sliding them out. Manipulate the compressor out of the engine.
