Tuesday, August 4, 2015

Switch The Key Lock Cylinder

The main lock cylinder goes into the Chauffeur's side door and allows you to manually lock the door using a explanation. Some vehicles too carry a jotter basic lock in the passenger door, on the other hand because the advent of the explanation fob, most late-model vehicles achieve not install a answer cylinder lock in the passenger door. Whether you gimmick on changing the clue lock cylinder, you must capture the inner door panel off the door.


Instructions


1. Remove any screws that secure the inner door panel to the inside door. In most cases, the door panel Testament not hold screws holding it in compass. Allot the bottom of the lock cylinder buttoned up one of the access holes in the sub frame.4. Pull the metal connecting rod attached to the left side of the door lock gone from the lock using a twosome of pliers.


Remove the screws that secure the armrest to the inner door panel. In most cases, this requires a socket and ratchet. The screws thread washed-up the backside of the armrest at an angle.


3. Whether this is the event, pull gone on the lower left corner of the door panel to pop the retaining clamp gone of the door. After removing the fundamental clamp, draw out to remove the further clamps by pulling the door panel off the door until all of the door panel clips are removed.2.



5. Remove the conserve seed that secures the lock cylinder to the door using an adjustable wrench and push the lock away through the front of the door.


6. Slide the new lock into the door and secure it using the jam nut supplied with the new lock and the adjustable wrench.


7. Push the connecting rod into the left side of the lock.


8. Place the inner door panel back onto the door and press all of the retaining clips into the doorframe. If you removed screws from the door panel, screw them back into place.


9. Secure the armrest to the inner door panel using the socket and ratchet.