Thursday, August 6, 2015

Switch The Rear Brake Footwear On The Ford Taurus

The rear brakes on a Ford Taurus can be replaced by the owner.


There is fly speck else influential than your vehicle's faculty to break off itself. The rear brakes on a vehicle dispense up to Fourty percent of the stopping aptitude that is used to bring your vehivle to a halt. Replacing the rear brake shoes on a Ford Taurus can be performed by the owner. As soon as the Chauffeur notices a modify in their brakes or when they close not seem as responsive, the brakes necessitate to be replaced now to prevent an likely accidents.


Instructions


1. Remove half of the brake fluid from the crack cylinder using a syringe. To allot the crack cylinder, expansive the hood of the vehicle. It is a metal cylinder located in front of the steering turn on the firewall that separates the engine from the item of the van.3. Raise the rear of the vehicle using a car jack. Place jack stands beneath the rear fender welds for support. Lower the vehicle onto the jack stands.4. Remove the brake hose bracket by unscrewing it from the frame side. Remove the retaining clips that secure the cable of the parking brake to the disc brake caliper. Separate the cable end from the parking brake lever.



The plastic container on top of the cylinder is what holds the brake fluid. Dispose of the brake fluid properly.2. Loosen the lug nuts on the rear wheels.



5. Remove the disc brake caliper locating pin from the support bracket. Rotate the caliper to prevent it from blocking the rotor. Remove the disc brake pads.


6. Inspect the rotor for wear. If necessary, replace the rotor.


7. Rotate the piston clockwise using the rear caliper piston adjuster tool until properly seated.


8. Install the new brake pads. Lay the caliper assembly in position on the disc brake pads. Use thread lock sealer on the brake pin retainer bolt. Install the bolt and torque to Twenty four ft-lb.


9. Secure the cable end onto the parking brake lever and replace the retaining clip for the cable on the caliper assembly. Attach the bracket and brake flex hose to the side rail. Torque to Eleven ft-lb.


10. Place the wheels back on the vehicle. Loosely place the lug nuts onto the wheel studs.


11. Raise the vehicle slightly using the jack. Remove the jack stands then lower the vehicle to the ground.


12. Bleed the brakes to remove any air from the lines.