1. 2
Coming
Unmarried Chapter
The starter on a Chevrolet Silverado One thousand five hundred is what gets the engine Stirring. Turning the ignition triggers the starter motor---which draws aptitude from the battery---to engage, turning the flywheel and kicking the Engine into system. When the starter on your Chevy goes elsewhere, the Motor lorry won't commencement and you're left stranded. This repair should share approximately Fourty five minutes to an generation.
Instructions
Remove the starter from the truck.6. Bolt the replacement starter onto your Chevy using the 3/8-inch ratchet, making sure that any shims that were previously on the block or starter are still there.7.
Disconnect the persuaded proclaim on the battery using an open-end wrench. This ensures you won't get shocked when disconnecting the starter from the power wire. As a backup, also disconnect the negative terminal.
3. Crawl beneath the truck and unbolt the heat shield, if the truck is equipped with one, using the 3/8-inch ratchet and socket set.
4. Unbolt all wiring from the starter using either the open-end wrench or the 3/8-inch ratchet and sockets, depending on accessibility. Make sure to keep all your bolts in a safe place; you will be using them when you reassemble the starter.
5. Pull out one of the two bolts that hold the starter to the block. Support the starter with one hand, and with your other hand slowly pull the second bolt. The starter is surprisingly heavy, although manageable, so don't unbolt it without first supporting the starter properly.1. Jack up the front of the Silverado and secure it on jack stands. Build decided the Motor lorry is solidly on the stands before you crawl underneath it.2.
Reconnect all wiring, then reattach the heat shield and battery terminals.
8. Try to start your Chevy. If it starts normally, then the job is complete. If you hear the starter motor grinding, repeat the process and add shims between the starter motor and the engine. This may take a few attempts.
