1. Remove the AM/FM radio antenna by turning the antenna mast in a counterclockwise line, then turning the mount's onliest accessible stone counterclockwise as well. This Testament Proceeds the shaft clamp underneath the mount, and the filled antenna can be manipulated gone of the antenna gap.
CB radio antenna in inventory siteReplacing an motorcar's inventory AM/FM radio antenna with a Human beings Band mannequin gives the antenna a "stealth" appearance and requires babe modifications to the mount. The standard CB user can change a automobile antenna mount for advantage with a CB antenna in approximately Twenty minutes.Instructions
The antenna cable may be hard-wired into the antenna and must be unplugged from the radio and pulled completely away. It may be laborious to convert this wire whether needed. Tying a chop of border or wire to the antenna wire and leaving it in situate last the radio is an apparent trick to attention its pathway intact.2. Exchange the antenna mount to accomodate the CB antenna's larger mast and wire connections. Depending on the replica, the mount can be disassembled To admit drilling the holes to a larger thickness. On some models, it may be easier to screw a thread adapter to the clear-cut mast connexion (available at building servicing stores) without reusing the enfeebled mount hardware. The standard connector ends for a majority of CB coaxial cables are RJ-8(x) style, which use a thread adapter to associate the coaxial side to the antenna mast. This adapter has a plastic polarity separator washer that prevents the center core from grounding out on the mount. Secure the cup-shaped old mount to the adapter with JB Weld or similar heat-resistant epoxy, taking care to keep the polarity separator washer in place. The top antenna bolt of the antenna adapter should stick out of the top of the mount, with the shaft clamp on the bottom.
3. Run the coaxial CB antenna wire to the radio location by using the string to pull it through the dashboard from the antenna mount. The cable is larger than a typical AM/FM radio antenna cable and has markedly larger connectors, so take caution to not damage the vehicle while pulling the cable.
4. Position the shaft clamp into the antenna hole and turn the top antenna adapter in a clockwise direction. The shaft clamp should pinch the metal lip of the hole and tighten the mount. As CB antennas are usually thicker and heavier than AM/FM radio antennas, it is recommended to install a common CB antenna spring between the antenna and the adapter thread.
