Brake lines and hoses are typically connected at Everyone shove with the metal borderline going into the hose. These lines and hoses are basic to receive apart on the other hand crave some particular steps to preserve the prerrogative brake fluid continuous and insure that no air enters the hydraulic step.
Instructions
Brake line to brake hose removal
1. Dwelling a capture container under the brake hose you are removing. Grip the disclosed heel box boundary wrench that fits the brake border.3. If either fitting is damaged, replace with a new fitting before reconnected the line and hose. Do not use vise grips during this process as they will damage the brake hose. Turn the fitting counter clock wise until it is free from the brake hose.
2. Brake fluid should be caught in the container you place under the brake hose. If brake fluid leaks onto the floor, Use a spill cleaning compound such as cat litter To cleanse up the spill. This should be done immediately to prevent slips. Once the residual fluid is contained, examine the brake line and hose connections for damage or cross threading. If you are removing the brake hose, use the line wrench to disconnect the hose and replace it with a new hose.
Accept a edge wrench the magnitude of the brake hose. Convenience the borderline wrench to occupancy the brake hose in abode. Bring about not twist the brake hose during this procedure as it Testament beginning severe damage to the brake hose and foundation it to burst during method. With the borderline wrench in levy, apply the cleared head box point wrench to unscrew the brake line from the brake hose connecter. With new fittings in place, hold the brake hose with the line wrench and slowly turn the brake line fitting clockwise until it is snug to the brake hose. Do not over tighten as this could damage both fittings and require replacement of both fittings.
4. Check the master cylinder reservoir brake fluid level and add fluid until it reaches the full line. Check the position of the brake pedal with the engine running. If the pedal is soft or goes all the way down to the floor, the brake system will need to be purged of air. Follow the year model service manual for specific bleeding process.
