7. Place the caliper over the rotor back onto the steering knuckle. Replace the mounting bolts and sleeves into the holes.
Reaching the Caliper Brake Pads
1. Jack up your vehivle using a hydraulic floor jack. Lay jack stands under your A-frame. Position the jack stands prerrogative to prevent injury from the machine falling. Deposit chocks latest the wheels to prevent them from rolling off the jack stands. Takings off your tire and spin meeting using the equitable sized lug wrench.
2. Remove the caliper from the steering knuckle without disconnecting your brake hose. A torque wrench may be needed to remove the bolts. Brace the caliper with a wire coat hanger.
3. Push in the out path of the outboard pad to remove it. This releases the mounting dowel from the gap in the caliper. Press on the other side to remove the other dowel. Push the pad gone of the backside of the caliper.
4. Pull outside the inboard pad.
Install New Pads
5. Border up the inboard pad so the spring clip on the back lines up with the gap/time in the caliper piston and locks into it.
6. Install the outboard pad over the caliper neb. This forces the mounting dowels to snap into the holes in the caliper to occupancy the outer brake in abode.
You've realized you exigency to interchange your brake pads. Although it sounds frightening, an Car store can helping hand build positive you admit the prerrogative brake pads for your automobile.Instructions
Torque the bolts to the specified amount for your car.8. Replace the tire and wheel using your lug wrench.
9. Pump the brake six to seven times to seat the pads against the rotor. The brake pedal should feel firm when the pads are seated.
10. Check the master cylinder fluid level and add brake fluid if necessary.
