The Toyota Previa muffler is not a compacted one to exchange. The hardest chip might be locating the prerrogative muffler for the year and replica Previa you hold. In other text, if it's a DX model Previa or an LE base Previa. Choosing the Trade-mark of muffler may be another defiance and then finding the availability of one. Toyota Testament keep one for approximately $350 plus shipping. Nevertheless you can good buy one in the aftermarket terrene for less than half of that with the equivalent affectionate of warranty and shipped to you equitable as quickly. Bosal is a good import aftermarket exhaust step manufacturer and you can invest in or course them over many district parts stores or catch them online. Condign beget positive you enjoy all the earful approximately our Previa before you cause.
Instructions
1. Lift the Previa all the course up on a automobile lift.
2. Set the flange connexion of the muffler inlet pipe condign forward of the rear axle.
3. Deposit on cutting glasses and gloves and aglow the torch. Abbreviate the two bolts on the muffler side of the flange connection until they are melted or chop below the flange itself. Turn off the torch.
4. Strike the muffler side of the flange with a hammer to seperate the two flanges. Provided you annex to, use the punch and hammer to knock out the cut bolts through the other flange. Once the separation of the flanges are complete, switch over to the safety glasses so you can see better.
5. Remove the muffler hangers (front and rear) from the rubber hangers on the frame of the Previa. Discard the old muffler.
6. Clean any remnants of the old gasket off of the pipe flange where you cut the muffler from using the gasket scraper.
7. Install the new muffler in the same manner you removed the old one. Do not tighten one side securely first and then the other, or you may kink the gasket.10. Lower the Previa and start it up to check for any leaks at the flange connection.
Insert the new gasket and connect the new muffler flange to the pipe flange. Connect with the Ten millimeter hardware placing the flat washer on the bolt head side of the flange and the lock washer and nut on the other side.
9. Secure the bolt head in place with the box wrench and tighten the nut with the gun and socket. Tighten one side snug. Then bring in the other side. Place the rubber hangers on the frame onto the muffler hangers to hold it in place for you. The rear axle will hold the inlet pipe in place.8.
