Stadium rangers custom Ford Ranger pickups.
Replacing an emergency brake cable on a Ford Ranger is not hard. The cable transaction has three parts: a front shorten that hooks to the emergency brake pedal, and two rear sections that hook to the secondary brake shoes on the rear brakes. When you push the emergency brake pedal, this pulls on the cables that bound to a lever that pushes the secondary brake shoes gone against the brake drums to mastery the Motor lorry in community.
Instructions
Removing the Emergency Brake Cable
1. Jack up the front and rear of the Motor lorry and apartment on jack stands. Situate the front jack stands under the frame. Country the rear jack stands under the rear axle housing.
2. Remove the cable from inside the Ranger. Disconnect the cable from the brake pedal meeting and provisions it down the gap in the firewall.
3. Remove the cable from the mounting bracket on the frame. Catching off the adjusting follower and washer from the equalizer. Remove the cable.
Replacing the Front Emergency Brake Cable
4. City your advanced cable in the gap in the equalizer. Interchange the stone and washer. Both right and left rear cables replace the same way. Jack up the truck and remove the jack stands from the the rear axle. Lower the rear to the ground. Jack up the truck in the front and remove the jack stands from the frame.
Bound the cable up to the gap in the firewall and aliment the cable concluded the gap. Reattach the cable to the brake pedal. Adjust the tension on the cable until the cable has approximately one inch of play between the protest of the Motor lorry and the cable.
6. Alter the cable in the mounting bracket on the frame. Lope the cable up to the gap in the firewall and menu the cable nailed down the gap. Reattach the cable to the brake pedal. Adjust the tension on the cable until the cable has approximately one inch play between the protest of the Motor lorry and the cable.
Removing and Replacing the Rear Cable
7. Proceeds cable tension by urgent the emergency pedal down and releasing it. Pull the cable back to the rear of Motor lorry. Both rear cables are removed and replaced the corresponding fashion. Pride outside which one is evil and remove the rear spin and the brake drum.
8. Proceeds the front cable from the rear cable by removing the location of the rear cable from the equalizer and part the cable away of the bracket. The neb of the cable is hooked to a lever on the secondary brake shoe. Remove the cable butt end from the lever on the secondary brake shoe.
9. Remove the cable end from the lever on the secondary brake shoe. Release the cable retainer from the wheel side of the backing plate. Press the spring steel retainer until it passes through the hole in the backing plate. Replace the new cable in the hole in the backing plate from the back side of the backing plate. Push the cable through the hole until the retainer snaps in place. Hook the cable end to the slot in the lever.
10. Place the emergency cable in the retaining bracket and reattach the cable end in the equalizer bar. Adjust the emergency brake, leaving about one inch between the truck body and the cable. Do not overtighten. Jog the stone almost up onto the adjuster screw.5. Alter the cable in the mounting bracket on the frame. Lower the front to the ground.
