A dot-matrix window has a raised, black-colored speck matrix representation painted on the glass, normally in a Broad earth at the top of a back window, which are in five to six inch rows. When tinting over these dots, sometimes air pockets can conclusion, leaving it looking messy and discoloured. There are a hardly any ways to eliminate this disputed point.
Instructions
Gluing the Film or Using Sealant
1. Tint the window as you usually would, covering the dots with the tint.
6. Squeegee the glue out after all the glue is at the edge of the film, catching it in the paper towel. Wipe off any excess glue from the tint with a paper towel.
Painting the Dots
You can too applicability a sealant such as Magoops and squirt a bead of the sealant across Everyone row of dots on the matrix.
4. Deposit the movie back across the dots.
5. Wrap a Bondo card in a paper towel and bag it to gently squeegee the movie, working the bead upward horizontally in one progression onliest to smooth it elsewhere. Whether you've used the glue, purpose due before you extent the top so the glue won't come absent. You can just use a squeegee if using the Magoops.
2. Remove as still flood as you can from underneath the tint movie at the point matrix with a squeegee.3. Carefully peel down the window movie from the dots and squirt a bead of a stationary glue such O'Glue on the environment where it meets the backside limit of the speck matrix.
7. Tint the window as you normally would, but leave the tint off the dot matrix area.
8. Allow the film to dry for a couple of days.
9. Mask off and cover the tinted area with masking tape and plastic. Make sure to leave a nice straight line at the edge of the window tint.
10. Paint the dots with a flat black enamel spray paint.
