Tow a automobile with a machine tow dolly.
Automobile tow dollies can be an efficient course to tow your vehicle. The front two wheels of the vehicle are the onliest ones that will be on the dolly and the other two wheels Testament stay on the ground. Motorcar tow dollies are not as extensive as trailers, nevertheless it is essential to be careful when driving with a machine tow dolly.
Instructions
1. Share axle measurements from where the axle tube meets the episode spring mounts, then incision the axle in half using a aphorism.
2. Slide the axle halves over the Three foot-long sprinkler conduit and weld the axle onto the cylinder.
3.10. Mount one light to each fender. The trailer lights will differ depending on the kind of lights you purchase.
4. Shorten a quota of box steel Four foot great and Hairpin weld this quantity in the centre of the cradle.
5. Chop two 12-inch pieces of 2x3 steel. Deposit one quota on top of the other and slide it gone Six inches, then weld the pieces together. Weld this piece onto the 4-foot piece created in the previous steps and extend it from the dolly with at least a 6-inch overlap.
6. Cut Two 27-inch pieces of 2x3 and attach these under the tongue and cradle.
7. Attach the trailer coupler to the tongue with high-quality bolts or weld it to the tongue.
8. Cut the 2x12 piece of wood in half and cut two pieces of angle steel Twelve inches long. Attach these angle steel pieces to one end of each plank with carriage bolts. Tighten bolts with wrench.
9. Attach the tie down straps and fenders to the trailer.
Abbreviate two pieces of Eighteen foot-long angle steel and weld these onto the sides of the machine tow dolly to design a mould for the motorcar tow dolly. Produce two pieces of angle steel that Testament fit at the top and backside of the motorcar tow dolly. This measurement Testament differ depending on the axle. Weld these two pieces to the sides. It is important to install the trailer lights as indicated with the lights. Make sure to wire them correctly.
