Bleed the brakes. Remove the brake fluid reservoir lid and pour in brake fluid until it is full. Have your helper sit in the driver's seat of the vehicle, pump the brake pedal three times and then hold it down.
On the other hand, whether it isn't in your budget to cut your vehicle to your regional repair shop, you can bleed the brakes yourself. With a diminutive letters and elbow grease this can be accomplished in a short date with relieve.
Instructions
1. Gash the lugnuts clear. Convenience your lug wrench to split handout all of the lugnuts on all four wheels. Corner the lug wrench on the lugnuts and turn it counter-clockwise until they rupture at liberty. Repeat this growth on all lugnuts and all wheels.
2. Jack the vehicle and remove the wheels. Compass the jack under the rear of the vehicle and jack it up. Assign the jack stands under the vehicle. Let the jack down until the vehicle is sitting on the jack stands. Modification the jack to the front of the vehicle and jack it up. Berth the jack stands under the front of the automobile for safety. Let the jack down so the vehicle is sitting on the jack stands.
3. Remove the wheels. Remove all lugnuts with the lugwrench, turning them counter-clockwise until they come off. Remove the wheels and set them aside.
4.Bleed Brakes on Dodge RAMBleeding the brakes on your vehicle is needed after replacing any brake parts that desire you to hole the seal on any apportionment containing the brake fluid. When the seal is broken in the fluid existence, it allows air in the lines that Testament not let the brakes supply properly. Bleeding the brakes can be done by your community mechanic.
5. Place the appropriate size socket on the bleeder screw located on the top of the brake caliper, and turn it counter-clockwise a quarter turn; this will release brake fluid and any air that is present. Turn the bleeder screw clockwise until tight. Have your helper release the brake pedal and then pump it again three times. Repeat the bleeding process. This process will be done to all four brake calipers.
6. Re-install the wheels and let the vehicle down. Place all wheels back on the vehicle and turn the lugnuts clockwise until they are tight. Jack the front of the vehicle and remove the jack stands. Let the front of the vehicle down to the ground. Move to the rear of the vehicle and jack it up, remove the jack stands, and let the vehicle down to the ground.
7. Tighten the lug nuts. When the entire vehicle is back on the ground, use your lug wrench to re-tighten the lugnuts.
