The Chevrolet Cobalt is an economy machine that took over where Chevrolet Cavalier left off. The Cobalt was the much-needed face-lift that the Cavalier needed, on the other hand the appearance was due approximately the sole circumstance that changed with the introduction of the Cobalt. The engine used in the Cavalier for the preceding generations was even the equivalent low-level engine that pushed outside by oneself One hundred fourty eight horsepower. Connect the cone filter to the hose adapter and secure it by tightening its hose clamp with the screwdriver. Bolt the "Z" and "L" bracket adapters onto the heat shield's openings clear "Z" and "L."6.
Connect the 3-inch elbow hose to the Two 3/4-inch intake tube and secure it with one of the hose clamps, tightening the screw with a screwdriver.
2. Include the 3/8-inch rubber hose into the brief Harbour on the side of the leading intake tube.
3. Assign the gasket onto the heat shield and bolt the leading intake tube onto the heat shield with the gasket in between. The heat shield Testament come with the nuts and bolts to be used with a ratchet and socket allot.
4. Dwelling the foam insulation all approximately the border of the heat shield. Levy the other gasket on the other side of the heat shield opening and bolt the tube adapter onto the heat shield.
5. Whether that is not Sufficiently capability, you can install a arctic air intake to add almost Sixteen horsepower to the Cobalt's engine.
Instructions
1.Compass the extreme hose clamp on the elbow hose's expanded borderline. Tighten it with the screwdriver.
7. Turn off the Cobalt's engine and disconnect the colorless battery cable. Remove the plastic engine subsume and apartment it to the side.
8. Pull the wire harness connexion from the Bulk air flow sensor on the inventory intake tube, and pull the sensor elsewhere of the inventory intake tube. Loosen the hose clamps from the top factor of the inventory air intake that connects to the throttle intent.
9. Remove the two bolts that dominance the air box to the fender wall. Remove the entire stock air intake and air box from the vehicle.
10. Connect the new cold air intake to the throttle body and tighten its hose clamp to secure it to the throttle body.
11. Insert the mass air flow sensor into the cold air intake's sensor port and reconnect its wire harness. Bolt the heat shield onto the fender wall using the stock air box bolts and drill holes.
12. Place the engine cover back onto the engine, pushing in the clips to secure it. Reconnect the negative battery cable and close the hood.
