Piston Emigration is all approximately disposal and patience.
Much under the tamest conditions, pistons are paragraph to loads of mechanical and thermal stresses. Removing one or aggrandized for replacement is no not difficult burden, one in most cases requiring entire Emigration of the engine. Although you may technically be able to convert a piston without removing the engine, odds are that you'll desire to remove the engine besides dispassionate To cleanse it and research for too damage. Procedures Testament vary glaringly from vehicle to vehicle in terms of both engine and piston Emigration.
Instructions
Removing the Engine
1. Disconnect all electrical harnesses, belts, fuel lines, cooler lines, sensors, discipline cables and linkages from engine. Label each harness connector removed with a piece of masking tape and permanent marker to ease engine re-installation.
2. Remove cooling fans and radiator to prevent damage to core, and remove hood to ease engine removal.
3. Unbolt air conditioner compressor from engine and lay it off to one side without disconnecting the hoses. This will allow you to avoid venting refrigerant into the atmosphere and paying to refill it.
4. Attach engine hoist to dedicated engine lift points as recommended by your manufacturer. Place a small amount of pressure on the engine by engaging hoist before unbolting any mounts; this will prevent dangerous engine movement during removal.
5.9. Identify the affected piston's connecting rod where it attaches to the crankshaft, and rotate that crankshaft so that rod's associated journal stops as far away from the engine block as possible. (This isn't strictly necessary in most cases, but will help increase clearance and prevent damage to the crankshaft journal during removal.)10. Remove the connecting rod nuts/bolt, and carefully brace the wooden dowel rod against the bottom of the piston.
Engage engine hoist and slowly lift engine free of car, avoiding (if possible) sending it flying through your windshield or radiator core support. Carefully lower engine onto a stable work surface or attach it to an engine stand if you have one and have opted to remove the transmission.
Removing the Piston
7. Remove (in this order): the intake manifold(s), valve cover(s), anything attached to the cylinder head including brackets, sensors, timing chain/belt, and finally the cylinder head(s).
8. Flip the engine over and remove the oil pan.
Unbolt torque converter from flex-plate, remove transmission housing bolts and carefully remove engine mount bolts. Many times removing the engine and transmission together (especially in front-wheel drive applications) will make for a far simpler removal and re-installation.6.
Tap the wooden dowel with your deadblow hammer to push the piston through the cylinder and away from the crankshaft. Stop tapping once the rod cap falls free and the rod studs rest against the crankshaft journal.
11. Slip the fuel line tubing sections over the connecting rod studs to keep them from nicking the crankshaft. Continue tapping the dowel rod until your piston falls out of its cylinder bore.
