Alternate the coolant in a Honda Coincide.
Draining the radiator in a Honda Accord is a straightforward manner. Coolant, or antifreeze, flows from the radiator to the engine to prevent overheating. Agape the hood and see the engine and radiator. They should be frore to the touch.3. Remove the radiator cap carefully by plam. Cars differ by year and base, and steps for routine maintainance vary based on the year and engine extent of your Honda Coincide. So always analysis the guidebook for your representation before doing any elbow grease on the vehicle.
Instructions
1. Turn the heater ascendancy inside the Assent to maximum heat. Whether you hold a digital thermostat, initiate the automobile, allot the thermostat to Ninety degrees and turn off the motorcar.
2. As coolant ages, inert residue builds up and the liquid becomes sluggish. When this happens, the engine in your Conform does not chilly properly. Over chronology, this can damage the transaction on your van.
There should be no steam from the radiator.
4. Stir under the automobile. Settle a filter pan under the radiator, then set and loosen the radiator void plug, using a wrench. The plug Testament be at the backside of the radiator. Let the coolant void into the pan.
5. Allot the extract bolt on the engine block. Cite to your instruction whether you are unsure of the bolt's address. Applicability the wrench to remove the bolt and washer.
6. Pull up on the reserve vehicle, near the radiator, to remove it. Dump the coolant elsewhere of the vehicle (and into the withdraw pan) and reseat the receptacle. Provided your Acquiesce is a six-cylinder model, remove the cruise control and ground control cables before pulling the reserve tank off the radiator. Replace the cables after dumping the coolant and replacing the tank.
7. Tighten the radiator drain plug once all the coolant has drained out of the radiator.
8. Replace the washer for the engine drain bolt, and reseat the bolt. Double-check the bolt to ensure it is tight.
9. Follow the instructions on the antifreeze container for mixing ratio. Mix the antifreeze with distilled water.
10. Follow the instructions on the antifreeze for mixing ratio. Mix the antifreeze with distilled water.
11. Loosen the bleeder bolt at the top of the engine, using a wrench. This will only be necessary if you have a four-cylinder model. Tighten the bolt again when coolant leaks out in a steady stream with no bubbles.
12. Check the fluid level again, and add additional coolant if necessary. You should see the fluid at the edge of the radiator opening.
13. Turn the car on and let it run until the engine warms. Wait until the fan comes on at least twice.
14. Turn the engine off and recheck the fluid level. Add additional coolant if required. You still want to see fluid at the edge of the radiator hole.
15. Replace the radiator cap, and fill the reserve tank to the maximum-level marking.
