Establish malfunctioning brake lights by replacing your brake aglow switch.
Brake lights hold been an decisive safety attribute on automobiles owing to the early twentieth century. Automakers are too required to install eminent mounted brake lights moreover to the habitual right-hand and left-hand brake lights. All three of these brake lights are actuated by a switch that is mounted near the brake pedal in the passenger compartment on most vehicles. Whether all of your brake lights cutoff working now, chances are you get a defective brake ablaze switch.
Instructions
Brake Light Switch Replacement for Newer Cars (1990 and Later Models)
1. Place the brake ablaze switch, which Testament be mounted near the axis mark of the brake pedal underneath the dashboard. Disconnect the wiring harness plug from the brake glowing switch by urgent in on the tabs on Everyone side of the plug, then pull the plug outwards. Push the wiring harness absent of the form.
2. Rotate the brake brilliance switch in a counterclockwise circuit. Pull the switch straight absent of the mounting bracket and discard it.
3. Push down on the brake pedal with one handwriting as you subsume the tabs of the modern brake light switch into the mounting gap on the bracket with the other ability. Let force of the brake pedal until it comes back up to its resting spot.
4. Rotate the brake shine switch clockwise until it clicks into abode. Plug the wiring harness into the fresh brake light switch until it snaps into place.
Brake Light Switch Replacement for Older Cars (1989 and Earlier Models)
5. Pull the metal U-shaped retaining clip from the brake switch mounting stud on the upper part of the brake pedal with a pair of pliers and set it aside. Slide the brake light switch towards the rear of the vehicle and away from the mounting stud, then discard it.7.
Locate the brake light switch on the brake pedal under the dashboard. Lift up on the tabs on the wiring harness plug, and pull the plug from the brake light switch.6.
Slide a new brake light switch over the mounting stud on the brake pedal.
8. Slide the retaining clip back over the end of the mounting stud until it locks into place.
9. Plug the wiring harness back into the brake light switch.
