Whether you occasion a current tailgate use, it may accept to come from the dealer or a used parts yard. They are infrequently inaugurate at Car parts stores. The mode is straight forward and does not need many tools or a grand measure of skill. This is a characteristic difficulty for those who custom the tailgate Often. The tailgate handle is a not difficult mechanism and is susceptible to breaking easily. The tools compulsory to pennies absent the holder are listed below.
Instructions
1. Lower the tailgate. Whether this is not practicable with what is left of the shaft, then operate the befitting torx mind and remove all the screws located in the inside of the tailgate. Grab the two rods running from the centre away to the outboard hinges and pull them simultaneously--the tailgate Testament bare.
2. Remove the two rods attached to the brake holder Eccentric person on the inside of the tailgate. To close this, simply custom the screwdriver to push down on the plastic locks attached to the lock handle. Once you have unsnapped the locks, pull the rods up and off the old handle.
3. Remove the old tailgate handle using the 10-millimeter socket and ratchet to remove the nuts holding it on. Lift the handle out of the front of the gate and discard.
4. Put the new handle through the front of the tailgate. Install the hold-down nuts and tighten them securely.
Try the handle a couple of times to make sure it is adjusted right. If not unsnap the lock on the rods and make them a little tighter. Reinstall the inner cover on the tailgate using the torx screws. At this point push the rod down into the lock on the handle and push the snap back on to hold it in place. Do the same thing to the other side.
6.5. Place one rod at a time in position to snap into the handle and pull on it just until you can feel the spring tension. If you pull any further, the tailgate will open.
