Worn or damaged brake border Trimmings are deadly due to they can element the brakes on your vehicle to malfunction, putting you at risk for getting into an accident or injuring others. Brake border Trimmings can leak when the brake masterly cylinder begins to fail from median manipulate. These Trimmings can be repaired easily by tightening the brake lines so they create not leak. Repairing the brake path Trimmings on your van or Motor lorry is a weekend project that Testament yield indefinite hours to full.
Instructions
1. Identify the site of the leak in your brake border. Unfastened the hood of your vehivle. Fix the master cylinder and brake fluid reservoir. The brake fluid reservoir is connected to the brake skillful cylinder, which connects the brake lines to the brakes. Both components are located along the side the engine bay. Observe the gaskets on the crack cylinder and brake reservoir for leaks. Probation encompassing the reservoir for any drips, puddles or evidence of sprayed fluids on all sides of the brake Trimmings.
2. Loosen the brake line by turning the wrench counter-clockwise. Use a wrench on the master cylinder mounting bolts to loosen and remove them. Remove the master cylinder from the vehicle once it has been unfastened. Disconnect the brake fluid sensor by unclasping the safety clip on the sensor to unplug it. Then, remove as yet of the brake fluid from the brake reservoir as you can, using a turkey baster or other suction object. Convenience a edge wrench to loosen the brake lines. Place the line wrench on the fitting where the line connects to the master cylinder. Then, reinstall the master cylinder. Reconnect and tighten the connectors. Refill the brake fluid reservoir to the midway point between the "Min" and "Max" lines. Torque the brakes by tightening the lines with a line wrench.
3. Adjust the torque settings on the brakes to the manufacturer's recommended settings so they are re-calibrated. Use a torque wrench to tighten the bolts on the caliper to torque the brakes. The bolts are located on the caliper of the disc brakes, behind the brake pads. The specific torque settings can be found in your vehicle owner's manual.
