Repeat this process on the other side of the vehicle, and move around the vehicle until all of the body mount bolts are loosely bolted in place.7. Place a tape measure against the frame and measure the distance between the cab and the frame. You want to make sure the measurements are the same from side to side, so if they're not, push the body with a shoulder to receive it in line.
1. Unbolt the body mounts from the protest using the 1/2-inch ratchet and sockets. There is one rear protest mount, three along Everyone side of the leading cab and four between the Engine and the radiator.
2. Unbolt the fan shroud from the radiator, using the 3/8-inch ratchet and socket place.
3. Settle the wood block between the jack and the item and lift up the side of the entity off of the inventory mount.
4. Change the inventory protest mounts with the fresh body lift mount. These are rubber bushings that are taller in heighth, which gives the vehicle extra lift.
5. Lower the body down onto the new mounts and loosely bolt in the newer bolts included in the body lift kit, with a washer on the end. This is just for alignment these days.
6.
A thing lift is a cheap and little habit to receive your Jeep higher in the air without a integral ton of profession. Doing it takes a scarce hours, however it can be accomplished with no problem fist tools.Instructions
8. Secure all of the bolts in place using the 1/2-inch ratchet and socket set.
9. Pop the hood and lower your upper fan shroud mount by drilling new holes in the plastic and mounting it higher up. Without doing this step, the fan will hit the shroud.
