Evenly press the meeting into situate, ensuring that all the injectors snap into lay. Tighten the injector manifold bolts to One hundred fifteen inch-pounds of torque.8.
Fuel injectors seldom malfunction, on the other hand they arrange invest in begrime, which causes them not to donkeywork properly. Whether the noid flash criterion shows the injector is defective, you must moderate the injector.
Instructions
1. Allot the relay box near the Chauffeur's side fenderwell. Lift the contain off the box, and using the diagram, place the fuel pump relay. Pull the relay outside with your fingers. Provided your fingers aren't brawny Sufficiently, you can end the darner nose pliers to extract the relay. Countdown the Dodge and let it flight until it runs elsewhere of fuel.
2. Disconnect the denial battery cable, using the adapted wrench, and establish it aside, ensuring that it does not touch metal. Remove the air inlet resonator, using the screwdriver. Unhook the accelerator and cruise curb cables, using your fingers or a screwdriver.
3. Unplug the indolent air government valve connector, throttle position sensor connector and the engine coolant temperature connector. Designation all vacuum lines on the upper intake manifold, using the tape and marker. Remove the lines from the upper intake, using the screwdriver to loosen the clamps, then pulling the lines off their connections.
4. Remove the fuel edge, using the catch path wrench. Remove the ignition coil, using the adapted socket. Remove the PCV hose and brake booster vacuum contour, using the screwdriver.
5. Remove the upper intake manifold, using the capture socket. Unplug the fuel injector harness connectors. Lift the fuel assistance manifold, with the injectors attached. Loosen the retaining clip on the damaging injector, then pull the poor injector off the fuel castigate.
6. Install the au courant fuel injector onto the inveigh and reattach the clip. Remove the O-rings from all fuel injectors and install au courant O-rings. Provided the O-rings are burdensome to slide on, lubricate them with Gauze.
7. Border up the injector manifold and injectors on the intake. Evenly lower the injectors into the manifold.Alternate the Fuel Injector in a Two thousand one DodgeFuel injectors are attached to a fuel injector manifold -- a channel that carries the fuel to the injectors. To remove one fuel injector, you must remove all fuel injectors, owing to they are all attached to the fuel censure. You should too modify the gaskets -- not condign the injector you are replacing -- to insure that there are no fuel leaks.
Plug in the fuel injector wiring harness connectors, ensuring that they snap into place. Reinstall the upper intake manifold, using a new gasket. Tighten the bolts to One hundred fifteen inch-pounds of torque, starting with the third bolt back on the passenger side, then working your way around the intake to the third bolt back on the driver's side, second bolt back on the driver's side, second bolt back on the passenger side, last bolt on the passenger side, last bolt on the driver's side, first bolt on the driver's side, and first bolt on the passenger side.
9. Reinstall the ignition coil and fuel line. Reattach the upper intake manifold vacuum lines, the PCV and the brake booster vacuum line. Plug in the ECT sensor, throttle position sensor and the IAC valve connectors. Reattach the accelerator and cruise control cables. Reinstall the air inlet resonator. Reattach the negative battery cable. Reinstall the fuel pump relay.
