With some van models, the manufacturer's door might not be of the factor the owner likes. Whether this is the process with your motorcar, you can interchange the senile door handles with designer ones from an Car detailing shop. You Testament obligation to duty within the door itself to disconnect and remove the door handle, content Emigration of the trim panel is all-important. The door handgrip is connected to the door's lock and lock cylinder.
Instructions
1. Make sure the car windows are rolled all the way up. Disconnect the car's negative battery cable as a precaution if the door contains any electrical devices such as power locks or windows.
2. Remove the inner trim panel from the door. Start by prying off or unscrewing the trim bezel from the inside latch and removing its control panel, disconnecting the electrical connector to it. Remove the lock cylinder's mounting bolt with a wrench or drill out its rivets, then remove the cylinder.5. Detach the door handle from the latch rod through the same access hole by removing its clip.
4. Disengage the plastic clip securing the rod that connects the latch to the lock cylinder. You will need to reach into the access hole on the inside of the door to reach it. Remove the manual window crank by rubbing a cloth behind the crank until the clip disengages. Remove all mounting screws, lift the panel off its clips and disconnect all electrical connectors.3. Peel back the watershield on the inner door, making sure you don't damage it.
Remove any bolts mounting the handle in place and remove the handle.
6. Place the new door handle onto the door, mount it with the old bolts and connect the latch rod to the handle with the rod's clip. Reinstall the old lock cylinder on the door with its old bolts or new rivets and reconnect it to the latch.
7. Reconnect the inner trim panel to the door in the reverse order of removal. Use new sealant on the watershield if it won't stick on the door.
