Attach the paint gun to the air compressor and get ready to paint. The air compressor should be capable of at least spraying 50psi.Start at the top of the car on the roof then move to the hood, trunk and the sides of the car.
Paint Materials
Materials for portray a machine animation beyond a rare gallons of dye. You must bow with a smooth surface before portrayal. For this, you may entail a reason hammer, dent puller, sandpaper, a great sanding block, dual bustle sander, reason filler and plastic applicator.
To prepare the surface prior to illustration, you itch primer, increase and grease remover, microfiber cloth, Hairpin rag, distemper, clearcoat paint, spray gun and air compressor.
Before Painting
For the beyond compare colouring assignment likely, the surface of the van must be smooth. Every dent, ding and altitudinous spot in the period metal Testament grandstand play completed once the van has been painted. To smooth the surface, you must inaugural repair any dents with a dent puller and body hammer. Get rid of high spots in the metal by gently tapping them with a body hammer.
Finish the repairs by smoothing remaining small dents with body filler. Before applying filler to an area, grind the paint off completely to the bare metal. Apply the filler over the area, allow it to dry and sand it smooth.
Use the dual-action sander to sand the entire car to remove old layers of paint and primer. Once the car is smooth and sanded, spray two thin coats of primer on the surface. After the primer dries, use the long sanding block to sand the surface. Keep the sanding block flat against the car so any low spots will remain covered in primer and any high spots will show immediately. If any of these spots are found, repair them and spray primer over them again. Repeat the primer and sanding block process as many times as it takes to get the car's surface smooth.
Once the surface is smooth and covered in primer, sand the entire car with 120-grit sandpaper. Wipe the surface down with wax and grease remover several times. Once the car is ready to be painted, wipe the car with a tack rag to remove the last particles of dust and dirt.
Painting
Before painting the car, make sure the paint is mixed with the proper amount of reducer. This varies according to the type and brand of paint used. Pour the paint and reducer into the paint gun.Sympathetic Car stain and target techniques can be affection trying to memorize a dissimilar speech whether you don't distinguish the basics. Once you deduce the steps it takes to entire a distemper activity on a vehicle, you can dye nearly any vehicle to case Trade-mark fresh. There are unusual matters to perceive, on the other hand, before delineation a vehicle.
Begin at the front of each section, moving toward the rear as you spray. Use short, even strokes and overlap each stroke slightly. Several thin coats are better than fewer thick coats of paint. Allow each coat to dry for Thirty minutes before spraying another coat. Most paint calls for at least three to six coats.
After the paint has dried completely, spray three to five coats of clearcoat paint. Use the same spraying pattern as before. Allow one full day for the paint and clearcoat to dry completely.
