Modify Constant Rear Glass in a Ford Expedition
The rear constant windows in the Ford Expedition are held in corner with diverse bolts and some exceptionally Powerful adhesive, all buried underneath the Expedition's interior trim. Replacing these windows might be a employment choicest left for a intent shop or Car glass association, on the other hand in the advent you occasion to tackle this one yourself, be prepared for a time or two of elbow grease on the Expedition. It is best kind to perform this inside, so the interior Testament not be exposed to the elements should you demand to close working once the broken down glass is outside.
Instructions
1. Remove the trim panels surrounding the glass carefully. Cut the adhesive away from the bolts holding the window in place.4. Use the socket set to remove the retaining nuts. Have a helper hold the glass during nut removal so the glass does not move before you are ready. The plastic Testament turn immaculate dependable before it breaks.
2. Booty the box cutter and abbreviate along the Seam where the adhesive contacts the existing window glass. Account highest caution here, as the razor blade in the box scalpel can disjunction easily or the machete may suddenly move in the direction you are applying pressure, resulting in injury. Depending on the window size, this can take up to several hours to complete.
3. You can inspire your fingers underneath the trim at the ceiling and pull away and elsewhere from the Expedition's target to pop it loose. The trim is held in habitat with a series of plastic tabs on the back side that seat into the protest. Whether you touch the trim eventuate to flex unnaturally or eye any loss of colour while pulling, let activity and dab another angle.
5. Pull the old glass carefully out of the way and set it aside.
6. Scrape away any leftover adhesive remaining on the Expedition's body where the old glass was mounted.
7. Lay the old glass down on a clean, soft surface with the inside portion of the glass facing down.
8. Run a ¼-inch wide bead of auto glass adhesive all the way around the edge of the replacement glass, allowing it to cure per the instructions on the adhesive's container.
9. Have a helper aid you in lifting the glass up and moving it into position. Press it firmly in place and reinstall the retaining nuts with the socket set.
10. Reinstall the trim in reverse of how it was removed.
11. Refer to the auto glass adhesive's specific instructions regarding curing time before operating the vehicle. If the vehicle is sitting in a warm area, leave the door windows cracked open to prevent heat buildup inside the Expedition before the adhesive is properly dried.
