Repair Damaged Rubber All over My Van Window
Rubber trim is commonly used encircling automobile doors and windows to hand prevent gone elements, such as shower, from getting into the vehicle. Over allotment, this trim can come damaged and create To hull off. Repairing the rubber trim is needed to enjoy any machine in admirable working computation and is a business that can be completed by any motorcar owner with decent a babyish bit of patience.
Instructions
1. Bare the door of the van where the rubber trim is damaged. Jewel the spot where it is damaged and stick a screwdriver into that spot. Gently, so the van does not entertain scratched, push down under the trim and do prying it off. Pry until Sufficiently of it is unpaid so that it can be peeled off. Provided the trim breaks off, begin again with a screwdriver.
2. Wash the area where the trim was located with Goo Gone to remove any leftover residue. Scrub it with a rag and allow proper time to air dry. Wash the area once again with automotive cleaner and water to remove any remaining residue. Dry off with a rag.
3. Apply weather stripping adhesive to the area where the rubber trim will go and then apply a coat to the new trim. Allow the adhesive Ten minutes to adhere to the car. Set the new rubber trim exactly in the same spot where the old one was located. Hold it tightly in place for a few minutes.
Sand down the freshly cleaned area with sandpaper to smooth out the surface. Sand in slow, circular motions until the entire area has been covered, and brush off the debris from the sandpaper with a paper towel.4.
