The O2 sensor will thread into the exhaust like a bolt, and you'll need to turn it clockwise to tighten.4. Plug the electrical connectors into the O2 sensor(s). Once the rust or corrosion happens, you'll annex to grip off the exhaust system. But you'll also need to know install an exhaust on a truck.
Instructions
1. Place the new exhaust system on top of the jack stands so that the entire exhaust is raised off the ground. If your truck does not sit high enough off the ground, you'll need to simply rest the exhaust system on the ground while you work. Make sure the exhaust is oriented so that the catalytic converter or converters are toward the front of the vehicle and the muffler is toward the rear.
2. Slide the exhaust system onto the hangers underneath the truck that are attached to the body. The hangers are composed of a metal hook with a rubber loop. The new exhaust will have a metal hook also. You'll need to slide the metal hook on the exhaust system through the rubber loop attached to the body's metal hooks.
3. Install the O2 sensors into the exhaust using the O2 sensor tool and socket wrench.
The exhaust development on a Motor lorry helps to conduct the exhaust gases elsewhere from the engine bay and safely gone the rear of the vehicle. Owing to exhaust gases ultimate outside of the engine are excessively calescent, it's beyond compare to labour on the exhaust course apart after the Motor lorry has completely cooled down. Over bout, most exhaust systems---unless they are stainless steel---will rust or corrode, exceptionally whether you alive in the northern hemisphere, due to the corrosive essence of the pungency and sand that is Often spread across the roads in winter months to melt solidify and snow.5. Place a gasket over the end of the exhaust piping, and bolt the exhaust piping to the exhaust manifold on the engine.
6. Turn on the truck and check for any exhaust leaks. You will be able to visibly see any exhaust gases leaking from the connection at the exhaust manifold. If there is a leak, separate the exhaust piping from the manifold, and readjust the gasket or replace it with a new gasket.
