Cognate a Gauze pump, the fuel pump in your Sebring moves petrol from one city to another.
The Two thousand one Chrysler Sebring Coupe utilizes an electric fuel pump mounted inside the fuel cistern to transfer fuel from inside the vat to the fuel injectors. These pumps can wear away and whether not replaced Testament dilute the proportions of fuel available to the engine. Replacing the fuel pump on a Two thousand one Chrysler Sebring can be accomplished finished a fuel pump access gap, located underneath the rear passenger seat cushion.
Instructions
Removing the Rear Seat Cushions
1. Pull outside on the two Proceeds tabs on the backside line of the rear seat cushion, using your hands, to disengage the front of the cushion.
2. Slide the seat cushion forward.
3. Lift the seat cushion away wound up one of the rear doors and remove it from the vehicle.
4. Pull the Floor-mat back outside from the floor pan, with your plam, to disclose the fuel pump advantage gap.
Removing the Fuel Pump
5. Disinfected the earth approximately the fuel pump utility gap, using a rag and an automotive cleaner.
6. Rotate the fuel pump module bell follower counterclockwise using a sizeable douse pump pliers, then proceeding it outside of the habit.
7. Slowly lift the fuel pump module outside of the fuel receptacle. Be definite to angle the module while you are removing it so as not to damage the fuel equivalent sending unit.
8. Pull the fuel pump electrical connector off the fuel pump with your labourer.
9. Pull the fuel pump downward, out from the fuel filter, to remove it from the module.
Installing the Fuel Pump
10. Slide a new O-ring onto the fuel pump outlet port. Then, press the fuel pump onto the inlet port on the fuel filter, using your hand.
11. Press the fuel pump electrical harness onto the new fuel pump, using your hand.
12. Lower the fuel pump module into the fuel tank.
16. Slide the seat backwards. Be sure to engage the hooks on the back of the cushion to the cups in the floor pan.17.Press downward firmly on the front of the seat to engage the front of the seat cushion to the latches on the floor pan.
14. Lay the carpet down over the fuel pump service hole.
15. Slide the rear seat cushion into position through the rear door.
13. Screw on the fuel pump module ring nut by turning it clockwise with a large water pump pliers.
