Transform a Rear-View Mirror in an F-250
The F-250 is a 3/4-ton pickup Motor lorry produced by the Ford Engine Business. F-Series trucks admit been in Industry on account of the 1940s and were much existence sold as of 2010. Although not as general as the smaller F-150, the F-250 caters to owners who longing a Rough, heavy-duty Motor lorry that can haul and tow copious loads. The rear-view mirrors on F-250s are designed specifically for towing, as they can be lingering many inches outward to accomodate Broad trailers. Replacing a damaged mirror should capture approximately one to two hours.
Set the door panel aside.5. Remove the door speaker to access the mirror wiring harness. Remove the speaker screws in a counterclockwise direction with a Phillips screw driver.
Remove the sail panel (a plastic portion due above the interior door panel at the front) by pulling it by help toward the rear of the door. Allot the panel aside.
2. Remove the window direction panel on the interior of the door by prying up at the front with a flat-blade screwdriver. Pull the window control panel forward and gone of its opening. Disconnect the four wiring plugs on the underside of the window control panel, pulling them absent by handwriting. Place the panel aside.
3. Remove the lens of the courtesy glossy on the lower side of the door panel, prying it absent with a flat-blade screwdriver. Establish the lens aside.
4. Remove the two screws that grip the door panel by backing them elsewhere with a Phillips screwdriver in a counterclockwise order. Lift the door panel straight up and out from the door.
Instructions
1. Airy the door.Pull the speaker from the door and pull the speaker wiring from the plug. Set the speaker aside.
6. Reach into the speaker hole and disconnect the mirror wiring harness by pulling it apart by hand. Remove the bolts holding the mirror (located where the sail panel was removed) with an 11mm wrench turned in a counterclockwise direction. Remove the mirror from the door, being careful to fish the wire out through the mounting hole in the door.
7. Mount the new mirror, using the above procedure in reverse order.
