Automotive collision repair shops can charge various hundred to over a thousand dollars for dent repairs and repainting damage after an accident. If these repairs are covered by insurance or not, it can much be expensive, causing you to stipend deductible or for the complete repair. You can accomplish most of these repairs Homewards, avoiding the collision shop completely.
Repairs
Collision repairs are mostly dents from life hit by or hitting another vehicle. Dents can be repaired a infrequent differential ways, from basic to burdensome.
The easiest arrangement is for shallow dents. Cause any household plunger, wet the dent with inundate and a little extent of dish soap and stick the plunger to the dent. Gently plunge the dent until it comes outside. You can slide the plunger encompassing and pull on disparate areas of the dent.
Another way can one be used provided you can impress to the bottom of the damaged item panel. Provided so, capitalization a hammer to tap the dent away. Once the dent is mostly gone, abode a metal dolly last the dent and appliance the hammer on the conflicting side of the panel. After the area is finished, spray another coat of primer and allow it to dry completely.
Refinishing
Wipe the repaired area with wax and grease remover or rubbing alcohol.This can be repeated in all of the holes several times until the dent is straight. Fill the small holes and the dent with body filler and let it dry. Sand the filler with 80-grit sandpaper until it is smooth with the car's surface. Sand the area again with 120-grit sandpaper to smooth the deep scratches of the 80-grit paper.
Paint Preparation
Spray the damaged area with a coat of dark primer. Use a long sanding block and 120-grit sandpaper to sand the area completely. Keeping the block level will reveal low and high points on the car's surface. Use a body hammer for the high points and more filler for the low areas. Once these are repaired spray more primer and sand again with the 120-grit paper. Tap the hammer on the panel and against the dolly to shape the metal.The persist and most dense approach is using a dent puller. Drill several holes in the dent with a drill. Screw the tip of the dent puller into one hole at a time and pull the handle towards your body to pull the dent out.
This removes dust, dirt and oils from your fingerprints. Spray three light coats of paint, covering the entire area. Wait Thirty minutes between each coat so that the previous one can dry. Spray three coats of clear coat paint, allowing each coat Thirty minutes to dry.
