The Toyota Corolla's starter sits on the front of its transversely mounted, four-cylinder, 1.6-liter engine. The first-rate groove to pocket money the starter is by working over the front of the vehivle and lifting it elsewhere from the top. The starter Engine is not accessible from under the motorcar, in that the frame cross member runs exactly below it. Whether your starter is failing or has desert, remove and exchange it, or holding it to an Car parts store and gain it bench tested.
Instructions
1. Emptied the hood of your Corolla and allot the denying battery terminal. Loosen the retaining bolt of the bad battery cable limitation with a wrench, then remove the cable from the battery terminal. Isolate the cable from the battery while you are working.
2. Remove the air cleaner meeting from the top of the engine by removing the wing seed on the rod in the centre of the air cleaner. Lift the housing off the engine, and remove the air intake hose from the Harbour on the radiator base, setting it away of the bag, very.
3. Fix the starter by looking straight down into the engine compartment between the radiator and the engine. Disconnect the wiring harness connector from the starter by pushing in on the locking tab, then seperate the connector from the starter.
4.8. Install the negative battery cable on the negative terminal of the battery. Install the clamp bolt through the cable end, and tighten it with a wrench.
Remove the upper and lower mounting bolts from the starter meeting with a socket and ratchet. Slide the starter back from the phone housing, and lift it outside of the engine compartment. Lower the current starter into district, sliding the nose cone into the gap on the phone housing, then install the two mounting bolts.
6. Tighten the mounting bolts to Twenty nine pound-feet with a torque wrench. Install the cable on the "Bat" terminal, followed by the retaining devotee, and tighten it with a wrench until it is secure. Plug the wiring harness connector into the connector on the starter Engine, making sure the two halves lock together.
7. Set the air cleaner on the retaining shaft on the top of the engine, and install the wing nut to retain it. Route the air intake hose to the port on the radiator support, and push it on.
Remove the follower from the "Bat" terminal on the side of the starter with a wrench. Remove the cable from the terminal, and establish it aside for momentarily.5.
