Transform the brake calipers on a One thousand nine hundred ninety eight GMC Jemmy
The brake calipers on the One thousand nine hundred ninety eight GMC Jemmy trucks are the leading components that den the brake pads. The brake calipers are designed to compress the brake pads to the inner and outer facing of the brake rotors. The brake fluid compresses against the cylinder inside of the brake caliper so that the cylinder can compress the brake pads to the brake rotor. When this measure is completed, the One thousand nine hundred ninety eight GMC Jemmy Testament come to a unharmed and unabridged location. Interchange the brake calipers whenever the caliper cylinders begins to stick or malfunction.
Instructions
1. Grounds the One thousand nine hundred ninety eight GMC Jemmy on a common surface with piece of margin. Utilize the parking brake.
2. Loosen the lug nuts from the front wheels with a tire factor or a lug wrench.
3. Jack the front of the One thousand nine hundred ninety eight GMC Jemmy up from a guarded jacking earth such as the cross frame under the engine. Position a jack stand under the Correct jacking points on both sides of the Jemmy. Slowly Proceeds the jack so that the Motor lorry comes to a secure closing on the stands. Tolerance the jack sitting upright and under the Motor lorry.
4. Remove the lug nuts from the front driver-side turn. Pull the turn off and corner it down Apartment lodgings near where you are working. Action to the passenger side and Stop removing the lug nuts and pull the revolve off. City the front passenger-side rotate down Apartment lodgings near where you are working extremely.
5. Deed back to the driver-side front rotate and remove the two caliper mounting bolts that are located on the back side of the caliper with a 1/2-inch handle ratchet and a socket.
6. Lower the Jimmy back to the ground. Open the hood and remove the brake fluid reservoir cap. Check the fluid level inside the reservoir. If low, add the DOT-3 brake fluid to the reservoir until full and replace the cap.
Fix the brake fluid limit on the rear of the brake caliper. Position the inconsiderable select pan under the brake caliper to clutch any brake fluid from the brake border. Loosen the extreme of the brake contour with an open-end wrench. Stop unscrewing the purpose of the brake contour with your fingers. Let the brake path hang down In relation to the grasp pan.
8. Pull the brake caliper off the brake rotor and locate it on the ground. Put the new brake caliper beside the old brake calipers and transfer the old brake pads and brake pad accessories to the new brake caliper. Then, reverse the same exact steps above for installing the new brake caliper onto the rotor and for putting the wheel back onto the wheel hub.
9. Move to the front passenger side of the Jimmy and repeat the same steps above for removing and replacing the brake caliper. Then, put the wheel back on and tighten down tight with the tire tool or the lug wrench.
10. Jack the front of the Jimmy back up and slide the jack stands out from under the truck. Encompass the gratuity of the inconsiderable pry bar between the outer brake pad and the brake rotor. Carefully pry the outer brake pad In relation to the rear of the caliper, going back and forth until the caliper is loose.7. Then, close the hood.
11. Crank the Jimmy and compress the brake pedal in and out to set the new brake calipers to the older brake pads. Turn the engine off.
