Sunroof drainage systems are relatively effortless to alternate.
The popularity of vehicle sunroofs has been steadily rising thanks to 2002. And while sunroof drainage systems keep improved over the second childhood to cache swiftness with the trend, parts discharge wear over hour and itch replacing. Happily, drainage systems are analogous between most brands, and can be replaced in a sporadic straight-forward steps at a just reward.
Instructions
1. Yawning the sunroof and fix the four drain holes inside the channel, one in Everyone of the four corners. Shiny elsewhere any accumulated debris from the channel by scraping absent hardened dirt and leaves with a screwdriver. Blow elsewhere the sunroof channel with compressed air.
2. Blow a hardly any shots of compressed air complete each drain gap. Listen for the sound of air blowing finished the internal drainage manner. You can normally hear when a blockage is cleared when a sudden burst of air pops wrapped up the drainage spouts under the turn wells in the front and rear of the vehicle. Too jab vacuuming debris gone of the filter holes with a powerful shop vac. If this does not clear the system, proceed To pace 3.
3. Insert the new 1/4-inch replacement plastic tubing into the drain hole and through the existing hose inside the vehicle. Continue sliding through the internal hose until the tubing stops sliding. Mount a 1/4-inch compression sleeve inside the tubing. A compression sleeve is a small metal tube with a rim on one end. Insert a washer between the replacement tubing and the small metal rim of the sleeve, and super glue the three pieces together.
Either it has hit a 90-degree angle or another connecting hose. Slide the tubing back out four inches and cut off any excess replacement tubing.4. Let dry for Fifteen minutes.
5. Slide the replacement tubing down inside the existing drain hose. Before the washer hits the drain hole, apply silicone caulking beneath the rim of the metal washer. The metal washer prevents the tube from sliding into the hose, while the caulking seals the tube in place. Repeat steps three to five for each drain hole.
