Life a family minivan, the Two thousand five Honda Odyssey is normally workman to a collection of stop-and-go traffic, or hauling a comprehensive load of passengers and goods. Over of this type of employment, the Odyssey's brake pads can wear gone in as brief as 15,000 miles. With the ever-rising reward of Car repair, this can add up over the enthusiasm of you vehicle. Happily, replacing the front pads on your Two thousand five Odyssey is something you can determine yourself and save cash.
Instructions
1. Loosen, on the contrary arrange not remove the lug nuts from the front of the vehicle.
18. Remove the Odyssey from the jack stands and lower it to the ground.19.
Remove the lug nuts and pull the front wheels from the vehicle.
4. Stare at the rear of the brake caliper and allot the two caliper bolts, one upper and one lower. Letter that the caliper bolts Everyone animation buttoned up a sleeve -- this sleeve is called the caliper pin.
5. Levy an open-ended wrench over the lower caliper pin. Loosen and remove the lower caliper bolt with a ratchet and socket, while holding the caliper pin from Stirring with the wrench.
6. Area an open-ended wrench over the upper caliper pin. Loosen, however end not remove, the upper caliper bolt with a ratchet and socket, while holding the caliper pin from Stirring with the wrench.
7. Swing the caliper upward, using the upper caliper bolt as the swivel purpose. This exposes the geriatric brake pads.
8. Grasp the antique brake pads and pull them from inside the caliper bracket.
9. Settle an exhausted brake pad inside the caliper, so that it is contacting the two pistons. Field the C-clamp so that the constant quota is contacting the rear of the caliper oppose and the screw lot is touching the antique brake pad. Tighten the C-clamp until the brake malicious is fully pressed against the calipers intent, this presses the piston into the caliper, creating the clearance needed for the advanced pads.
10. Remove the C-clamp and the out of date brake pad.
11. Assign the new brake pads into the caliper bracket, just as the old ones came out.
12. Pivot the caliper downward and over the new brake pads.
13. Hand-tighten the upper and lower caliper bolts.
14. Tighten the upper and lower caliper bolts to Thirty seven foot-pounds of torque, using a torque wrench and socket, while holding the caliper pins with a wrench.
15. Repeat steps Four through Fourteen for the brakes on the other side of the vehicle.
16. Place the wheels on the vehicle and hand-tighten the lug nuts.
17.Tighten the lug nuts to Eighty foot-pounds of torque, using the torque wrench and a socket.
2. Elevate the front of the vehicle using a floor jack and secure it with jack stands.3.
Press and release the brake pedal repeatedly until it feels firm.
