The front brakes on a Dodge ram avail a rotor and caliper meeting to slow the Motor lorry down. Hydraulic fluid is forced buttoned up steel lines connected to a caliper meeting at Everyone shove. The caliper meeting contains two brake pads, Everyone clamping down on a CD, called a brake rotor. The rotor is connected to the impel axles of the Motor lorry so that when clamping beef is applied to the rotors, the comprehensive axle and turn slow down with the rotor. When the pad info in the caliper gets to be all over an eighth of an inch thick, you Testament duty to alternate the pads and proof the rotor for wear.
Instructions
1. Division the lug nuts loose using a tire wrench. Turn the lug nuts a quarter turn counterclockwise nevertheless cause not unseat the turn from the revolve hub. You solitary longing to loosen the lugs dependable Sufficiently so that you Testament be able to remove when when the Motor lorry is off the ground.
2.12. Re-mount the wheel on the wheel hub and tighten the lug nuts.13. Lower the Dodge Ram to the ground and torque the wheel lug nuts to One hundred foot-pounds using a torque wrench.
3. City jack stands under the front pinch welds located directly under the Chauffeur and passenger side doors.
4. Endure to remove the lug nuts and pull the turn off the circle hub meeting.
5. Remove the Dodge Ram's upper and lower bolts holding the caliper on the caliper mounting bracket.
6. Pull the caliper up off the Ram's rotor and secure it to the coil springs above the brake meeting.
7. Probation the brake rotor for Exorbitant scoring, pitting or warpage. Whether the brake rotor is damaged in any system, slide the aged rotor off the hub meeting (it Testament slide equitable off) and slide on a late brake rotor.
8. Tap the brake pads out of the caliper assembly using a rubber mallet.
9. Placing the face of one of the old brake pads over the piston, force the pad against the piston with a C-clamp. The piston will collapse back into the Dodge's caliper housing. The piston has a boot surrounding it. Be sure not to damage the caliper piston boot in any way during this process. The piston boot should collapse into the caliper in an accordion-style manner.
10. Insert the new brake pads into the caliper assembly and reassemble the brake assembly. Make sure that you torque the caliper bolts to the correct torque specifications listed in the vehicle service manual for your specific year of Dodge Ram. Not all years have the same torque specification. If the bolts are not tightened properly, your brake assembly could come apart during normal driving.
11. Spray the entire brake assembly with brake parts cleaner. Make sure that you remove all traces of oil (from your fingers), dirt and any other debris from the surface of the brake rotor and pads.
District the jack under the Ram's front crossmember and jack up on the Motor lorry. Never jack up on any object of the Motor lorry that is not a structural member. For instance, never jack up on the transmission, engine or any of the item. Solitary the frame and subframe Testament relieve the abundant weight of the vehicle.
Set the dial on the torque wrench to One hundred foot-pounds and turn the lug nuts clockwise until the wrench clicks indicating that the correct torque value has been reached.
