3. Hoist the front of the Jeep with a jack, then position a establish of jack stands under the frame or front axle to assist the Jeep. Lower the jack until the Jeep is resting securely on the jack stands, then pull the jack elsewhere from under the Jeep so you don't annex to donkeywork encompassing it.4.
Instructions
1. Govern the hood of the Jeep and fix the contravening battery cable on the battery. The battery in the Jeep Wrangler is located on the passenger's side of the engine compartment against the firewall.
2. Remove the dissension battery cable from the battery terminal after loosening the retaining bolt with a wrench. Isolate the cable from the battery while you drudge.
Your Two thousand one Jeep Wrangler has a starter Engine to spin the internal parts of the engine, building Sufficiently compression and Glimmer to begin the engine. Provided the starter Engine on your Jeep stops working, is dragging or makes grinding noises, it is extent to assessment and maybe replaced the starter. Replacement starter motors are eagerly available at most Car parts stores, from any Jeep dealer or all the more ended many rescue yards.
Establish the starter Engine on the passenger's side of the engine, near the back, working from under the Jeep. Boast the wiring harness connectors on the rear of the starter solenoid, mounted on top of the starter. One connector is a push-in style and the other is a stud with a retaining aficionado.
5. Disconnect the "S" connector from the starter solenoid by urgent the locking tab, then unplug the connector. Put the wire aside then remove the aficionado from the "B" terminal with a socket and ratchet. Slide the wire off and settle it off to the side too.
6. Set the two mounting bolts on the front of the starter. Remove them with a socket and ratchet, starting with the backside bolt antecedent. Slide the starter back until the nose cone clears the gap in the call housing. Lower it absent of the engine compartment.
7. Lift the brand-new starter into dwelling and slide the nose into the gap in the bell housing. Install the two mounting bolts and tighten them with a socket and ratchet. Plug the "S" connector into the back of the solenoid, making sure the locking tab engages then slide the ring connector from the larger wire onto the "B" terminal. Thread the retaining nut onto the terminal and tighten it with a socket and ratchet.
8. Raise the Jeep off the jack stands with your jack, remove the stands from under the Jeep and lower the Jeep to the ground. Install the negative battery cable on the negative terminal of the battery then tighten the retaining bolt with a wrench.
9. Test the starter repair by attempting to begin the Jeep. If it functions correctly, the repair was successful.
