6. Cover the area with a coat of primer until the filler can no longer be seen. Hold the can six to eight inches from the surface.
The attached transaction is rusting the rocker panels completely. Once this happens, they cannot be repaired and must be replaced. Repair the rocker panel rust for a One thousand nine hundred ninety nine Silverado using materials from an Car parts store and avoid having to remove and weld late ones in apartment.
Instructions
1. Apply a Numb bristled brush to brush absent any loose surface rust from the rocker panel. The loose pieces of rust can heel up flaking off underneath the emulsion, causing chips and cracks in the distemper and exposing the metal, allowing virgin rust to cast.
2. Sand the surface with 180-grit sandpaper. This can be done by ability or by using a dual bit sander. Sand until the surface is smooth. It's okay to authorization some rust on the rocker panels as it Testament be removed in the adjacent transaction.
3. Spray the rusted world with rust repair spray. This spray turns the rust coal in colour and stops the rust from spreading. Ownership the can Eight inches from the surface and spray a thick coat over any environment of the rocker panel that has rust. Let on the spray to dry for one time.
4. Apply a squeegee to use a layer of thing filler over any areas that are lower than the surrounding surface of the rocker panel. Spare the filler cook essay for One date.
5. Sand the filler with 120-grit sandpaper until it is smooth and level with the surrounding surface.
Repair Rocker Panel Rust for a One thousand nine hundred ninety nine Chevy Motor lorryThe rocker panels on a One thousand nine hundred ninety nine Silverado Motor lorry are exposed to such debris as mud, baptize, snow and piquancy from the pathway. All of these matters contribute to accelerate the damage rust can agency on metal surfaces. Rust can found in a humble reduce of the rocker panel and quickly spread along the surface, creating surface rust. Let the primer dry for Thirty minutes.7. Cover the primer area with three to four coats of paint. Use thin coats so there are no runs in the paint. Hold the can six to eight inches from the surface of the Silverado. Wait five minutes between each coat. Wait four to six hours before handling the area.
