Set your Silverado tailgate and save the mechanic's repair costs.
Some problems on your Chevy Silverado's tailgate door can be graceful effortless to establish. Issues coextensive a messed-up alignment or a handle that doesn't seem to drudge can regularly be matters that simply hope for adaption or reconnection. In some cases, you Testament possible essential to disconnect the tailgate configuration the Motor lorry to create such adjustments. Whether there are other augmented complicated problems, particularly related to object damage, you might extremity to remove the tailgate and moderate it.
Instructions
1. Govern the Motor lorry's tailgate. Detach the retaining cables by lifting their spring retainers upward and sliding their cables off the pins. Remove the bolt at the tailgate's lower ethical hinge for a Two thousand one Silverado or following.
Use a sturdy wire to link the rod back with the handle--something as simple as a twist-tie can work.6. Install the old tailgate or a new one in the reverse order of removal. Slide the left-side hinge pin into the frame and position the right-side hinge pocket onto the body hinge pin. Disconnect the left hinge pin, which is connected to the tailgate, by sliding the tailgate to the honorable to remove it from the Motor lorry; you'll call for an additional male to buttress its weight.
3. Adjust the position of the bar strikers on the rear frame provided the tailgate's alignment is an question. Loosen the strikers with a Torx bit to copper their positions; make small adjustments at a time.
4. Loosen and move the latches for the tailgate handle if needed. Pry off the handle bezel with a trim tool or flat screwdriver, remove the handle mounting bolts on the back end and detach the handle's control rods to arrive the latch. Loosen the latch's mounting bolts to adjust its position and then reassemble the handle.
5. Reconnect the control rods to the handle if you see that they have broken off--this is the leading cause of a handle no longer working.2. Lower the tailgate to where its hinge pocket on the hold up side aligns with the hinge pin and can be disconnected. Lift the right side of the tailgate off the right hinge pin.
Reconnect the retaining cables to their pins.
