You can install stereo speakers in your One thousand nine hundred ninety nine S-10.
1999 Chevrolet S-10 pickup trucks were normally equipped with a plant stereo and speakers. Provided the existing speakers bear broken or worn gone, you can install dewy speakers into the stereo speaker locations without requiring any specialized electronics apprehension. Alone basic tools and a diminutive age are required.
Plug the recent speaker in and place it in the door. Screw the speaker in with the 9/32-inch screws.9.
Slide the grille to the rear to pull off.
2. Remove the 9/32-inch bolt-head screws on the boundary of the speaker. Pull the speaker away of the cavity and unplug the wiring connected to the back.
3. Plug the wiring into the inexperienced speaker and settle the speaker in the opening. Screw the speaker in habitat with the 9/32-inch bolt-head screws. Moderate the grille and screw it in community with the Phillips screws.
4. Repeat Steps One nailed down Three on the left side of the dashboard.
Door Speakers
5. Remove one Phillips screw from the trim surrounding the door Proceeds on the fair side door.
6. Remove two 9/32-inch bolt-head screws located on the backside side of the door pull application.
7. Pry encompassing the edges of the door panel with a panel thing to Proceeds the retaining clips holding the door panel to the door.
8. Remove the Torx T9 screws on the frontier of the speaker. Pull the speaker elsewhere and unplug the wiring connector.
Instructions
Dash Speakers
1. Remove two Phillips screws from the top of the speaker grille located on the fitting side of the sprint board.Replace the door panel by reversing your steps. Repeat the steps above on the other door of the truck.
