Twist the two pins that retain the hold-down springs Ninety degrees to Proceeds the springs. Remove the springs and pins. There is a ownership down spring in the centre of Everyone shoe.4.
The drum brakes on your 2001 Ford Taurus are expanded complicated than the front CD brakes, however and wear away exceeding slowly. You should observe the rear brakes in your Taurus every 30,000 miles and alternate the shoes whether cardinal. Replacement pads can be purchased at most auto-parts stores.
Instructions
1. Loosen the rear lug nuts and lift the vehicle with a jack. Lower it securely onto a jack stand and remove the spin and brake drum. The lift objective is on the constituent of the frame lambaste that curves outwards ahead of the rear tire. Your Taurus owner's tome has a diagram.
2. Pry the involve from the centre of the hub with a flat-head screwdriver. Remove the peanut underneath and slide the hub meeting off the spindle.
3.
Airy drum brake meetingDrum brakes job by pushing a duo of pads or "shoes" outwards, against the inside of a drum attached to the rotate hub. This creates friction to slow the turn.Pry the shoes apart at the top and pull them outwards, disconnecting them from the cylinder. The parking brake lever attaches to the top of the rear shoe with a pin and C-clip. Pry the clip outside and remove the lever. Pull the shoes, adjuster and spring gone as a unmarried unit.
5. Twist the star-edged follower in the centre of the adjuster until the adjuster is as short as practicable. Remove the two springs, noting how they attach. Slide the shoes elsewhere of the adjuster, leaving it in city on the floor. It is relevant not to attach either bound of it upside down. A lever is attached to the front shoe. Tilt and remove it.
6. Install the lever on the front shoe and slide both shoes into the adjuster. Attach the lower spring, then account needle-nose pliers to attach the upper spring. Berth the meeting in the brake housing and reattach the parking brake lever. Seat the tops of the shoes on the brake cylinder and install the hold-down clips, ensuring that their pins sit in the grooves. Twist the adjuster star until the shoes are nearly to where the drum Testament sit.
7. Install the hub and hub devotee, torquing to One hundred eighty eight to Two hundred fifty four ft-lbs. Push the embrace into assign. Spray down the full brake assembly with brake cleaner, following the instructions on the can. Install the brake drum and wheel. Hand-tighten the lug nuts and lower the car. Tighten the lug nuts fully. Repeat on the other side.
8. Make several low-speed stops in forward and reverse To admit the brakes to self-adjust. Once the brakes feel normal, it is safe to drive on the road.
