Some machine repairs and concervation can be very challenging for most do-it-yourselfers, and some, such as oil changes or tune-ups, can be effortless. Replacing a vehivle's impel shaft can be somewhat challenging provided you've never tackled it before and are easily intimidated. Once you feature there are aloof a infrequent steps in the formation, you may be able to modify your machine's operate shaft in your own driveway.
Instructions
1. Facilitate the machine on ramps or jackstands for child's play access to the backside of the motorcar. Set the emergency brake or for a manual car put it in gear so the drive shaft does not turn while unbolting.3. Remove the bolts from the rear yoke.
Go after the manufacturer's directions for either Slogan. Levy the van in impartial.2. Place the rear yoke and aim the speck of the drive shaft at the yoke to ensure that the new drive shaft goes in in the same position as the old one when it came out.
If need be, remove one, go release the emergency brake, turn the drive shaft to remove another, and repeat until all four are removed. Use a crowbar, if needed, to pry the drive shaft from the yoke.
4. Disconnect the drive shaft from the transmission. Pull the rear part of the drive shaft towards the rear of the car to remove it, being careful not to damage the seals.
5. Install the new drive shaft by following the steps above in reverse order. Note: when connecting the shaft to the transmission, it only fits in one way, so rotate the drive shaft until it slips into place.
